Sprue Bits

Announcements, Corrections, & What-Not

This new section to Internet Modeler will contain corrections to past articles, general modeling announcements, and whatever else that comes in that doesn't fit anywhere else. If you have anything that would fit in here, please e-mail it to the publisher, Chris Banyai-Riepl.

Additions

Antony Morgan also sent some additions to Al's Bell 47 article back in November of 2001:

"PAVLA also did one. The lattice-work was again etched brass, and the remainder was injected plastic. Not a bad little kit, but it is another one better used only as a parts and decals source. Additionally, EDUARD and PART produce etched-brass sets for the Italeri kit that allows the modeler to replace the entire plastic lattice-work assembly (again) with flat parts."


pragolog-sm.jpg (5410 bytes)

< Scaleworld

Columns Index >